How To Make My Own Shower Pan

How to Make Your Own Shower Pan

### Introduction A shower pan is a waterproof barrier that is installed on the floor of a shower stall. It helps to prevent water from leaking through the floor and damaging the subfloor. Shower pans are typically made of acrylic, fiberglass, or tile. In this article, we will show you how to make your own shower pan using acrylic. ### Materials and Tools * Acrylic sheet (1/4 inch thick) * Shower drain * PVC pipe (2 inches in diameter) * PVC cement * Hacksaw * Drill * Screwdriver * Level * Tape measure * Pencil * Utility knife * Silicone caulk * Grout ### Step-by-Step Instructions 1.

Measure the Area:

Use a tape measure to measure the area where you want to install the shower pan. Make sure to add 2 inches to the length and width of the area to allow for the lip of the shower pan. 2.

Cut the Acrylic Sheet:

Use a utility knife to cut the acrylic sheet to the desired size. Make sure to wear gloves and safety glasses when cutting the acrylic sheet. 3.

Install the Drain:

Place the shower drain in the center of the area where you want to install the shower pan. Use a pencil to mark the location of the drain. Cut a hole in the acrylic sheet at the marked location. 4.

Install the PVC Pipe:

Cut a 2-inch long piece of PVC pipe. Use PVC cement to glue the pipe to the shower drain. Make sure that the pipe is pointing straight up. 5.

Level the Shower Pan:

Use a level to make sure that the shower pan is level. If the shower pan is not level, it will not drain properly. 6.

Caulk the Edges:

Use silicone caulk to caulk the edges of the shower pan. This will help to prevent water from leaking through the shower pan. 7.

Install the Grout:

Use grout to fill the joints between the shower pan and the surrounding tiles. This will help to create a waterproof seal. ### Tips * When cutting the acrylic sheet, use a sharp utility knife and make sure to score the sheet several times before cutting through it. * When installing the shower drain, make sure that it is properly seated in the hole. * When installing the PVC pipe, make sure that it is securely glued to the shower drain. * When leveling the shower pan, use a level that is at least 2 feet long. * When caulking the edges of the shower pan, use a silicone caulk that is specifically designed for use in wet areas. * When installing the grout, use a grout that is specifically designed for use in wet areas. ### Conclusion Making your own shower pan is a relatively easy and inexpensive project that can be completed in a few hours. By following the steps outlined in this article, you can create a waterproof shower pan that will last for many years to come.