Installation A Sioux Chief Shower Drain Comprehensive Guide

Installation of the Sioux Chief Shower Drain: A Comprehensive Guide

Are you looking to upgrade your shower drain system with a new Sioux Chief drain? This guide will provide you with a step-by-step overview of the installation process, ensuring that your new drain is properly installed and functioning optimally.

Gather the Necessary Materials

Before you begin, make sure you have all the necessary materials on hand:

Sioux Chief shower drain
Wrench
Screwdriver
Plumber's putty or silicone sealant
Thick plastic sheeting (optional)
Bucket or bowl

Prepare the Shower Base

Start by removing the existing drain cover and strainer. You may need to use a screwdriver to loosen the screws holding them in place. Once the old drain is removed, clean the shower base thoroughly, removing any dirt or debris that may interfere with the installation of the new drain.

Install the Drain Gasket

Next, take the drain gasket and fit it over the tailpiece of the new drain. The gasket will help create a watertight seal between the drain and the shower base.

Apply Plumber's Putty or Silicone Sealant

Now it's time to apply plumber's putty or silicone sealant around the base of the drain. This will help further seal the drain and prevent leaks. Apply a generous bead of sealant to the bottom of the drain flange and smooth it out with your finger or a putty knife.

Position the Drain

Carefully position the new drain in the shower base, aligning it with the drain hole. Press down firmly to ensure a good seal. If you're having trouble aligning the drain, you can use thick plastic sheeting to create a temporary guide.

Secure the Drain

Use the included screws or bolts to secure the drain in place. Tighten them just enough to hold the drain securely without overtightening them. Overtightening can damage the drain or the shower base.

Reinstall the Strainer and Cover

Once the drain is secured, reinstall the strainer and then the drain cover. Make sure that the drain cover is facing the correct direction for optimal drainage.

Test the Drain

Finally, test the drain by running water through it. Check for any leaks around the base or the strainer. If you notice any leaks, try tightening the screws or bolts further. If the leaks persist, you may need to apply more plumber's putty or silicone sealant.

Congratulations!

You have now successfully installed your new Sioux Chief shower drain. Congratulations! You can enjoy a worry-free showering experience, knowing that your drain is properly installed and will perform flawlessly for years to come.