How To Replace Shower Tile Walls

Replacing shower tile walls is not as difficult as it may seem. With a little planning and effort, you can do it yourself and save money. Here are the steps on how to replace shower tile walls:

Step 1: Remove the Old Tiles

Start by removing the old tiles. Use a hammer and chisel to break up the tiles into small pieces. Be careful not to damage the walls behind the tiles.

Step 2: Clean the Walls

Once the old tiles are removed, clean the walls thoroughly. Use a sponge and a mild detergent to remove any dirt or debris. Rinse the walls with clean water and let them dry completely.

Step 3: Apply Backer Board

Backer board is a waterproof material that provides a stable surface for the new tiles. Cut the backer board to fit the walls and screw it into place. Use a level to make sure that the backer board is level.

Step 4: Apply Thinset Mortar

Thinset mortar is a type of adhesive that is used to attach the tiles to the backer board. Apply a thin layer of thinset mortar to the back of each tile and press it into place on the wall. Use a level to make sure that the tiles are level.

Step 5: Grout the Tiles

Grout is a mixture of cement and sand that is used to fill the joints between the tiles. Apply the grout to the joints using a grout float. Use a damp sponge to smooth out the grout and remove any excess.

Step 6: Seal the Grout

Once the grout has dried, seal it to protect it from moisture. Apply a grout sealer to the joints using a paintbrush. Allow the sealer to dry completely.

Step 7: Install Fixtures

Once the tiles and grout are dry, you can install the shower fixtures. Screw the showerhead, faucet, and drain into place.

Tips for Replacing Shower Tile Walls

* Use a level to make sure that the tiles are level. * Apply a thin layer of thinset mortar to the back of each tile. * Press the tiles into place firmly. * Grout the tiles using a grout float. * Seal the grout to protect it from moisture. * Install the shower fixtures.