How To Replace Shower Door Water Guard

How to Replace a Shower Door Water Guard

A shower door water guard is an essential part of any shower enclosure. It helps to keep water from leaking out of the shower and onto the floor. Over time, water guards can become worn or damaged, and they may need to be replaced. Replacing a water guard is a relatively simple task that can be completed in a few hours.

Here are the steps on how to replace a shower door water guard:

1. Remove the old water guard.

The first step is to remove the old water guard. To do this, simply use a flathead screwdriver to pry the water guard away from the shower door. Be careful not to damage the shower door or the water guard.

2. Clean the shower door.

Once the old water guard has been removed, it is important to clean the shower door. This will help to ensure that the new water guard will adhere properly. To clean the shower door, simply use a mild soap and water solution. Rinse the shower door thoroughly and allow it to dry completely.

3. Apply the new water guard.

Once the shower door is clean and dry, you can apply the new water guard. To do this, simply peel off the backing of the water guard and press it into place on the shower door. Be sure to align the water guard with the edge of the shower door.

4. Trim the water guard.

Once the water guard is in place, you may need to trim it to fit. To do this, simply use a sharp knife or scissors to cut the water guard to the desired length. Be sure to cut the water guard carefully so that you do not damage it.

5. Seal the water guard.

Once the water guard is trimmed, you will need to seal it. To do this, simply apply a bead of silicone caulk around the edge of the water guard. Be sure to smooth out the caulk with your finger or a putty knife.

6. Allow the caulk to dry.

Once the caulk has been applied, you will need to allow it to dry completely. This may take several hours or overnight. Once the caulk is dry, the water guard will be installed and ready to use.

Replacing a shower door water guard is a relatively simple task that can be completed in a few hours. By following these steps, you can ensure that your shower door water guard is properly installed and will help to keep water from leaking out of the shower.

Tips for Replacing a Shower Door Water Guard

Here are a few tips for replacing a shower door water guard:

Be sure to choose the right size water guard for your shower door. The water guard should be long enough to cover the entire length of the shower door and wide enough to overlap the edge of the shower door by at least 1 inch.
When applying the water guard, be sure to press it into place firmly. This will help to ensure that the water guard will adhere properly.
When trimming the water guard, be sure to cut it carefully so that you do not damage it. Cutting the water guard too short will prevent it from sealing properly.
When sealing the water guard, be sure to apply a bead of caulk around the entire edge of the water guard. This will help to prevent water from leaking out of the shower.
Allow the caulk to dry completely before using the shower. This will help to ensure that the water guard is properly sealed.