How To Measure For Shower Door Seal

How to Measure for Shower Door Seal

Replacing the seal on your shower door is a relatively simple task that can be completed in a few hours. However, it is important to measure the door correctly before ordering a new seal. If the seal is too small, it will not fit properly and will not prevent water from leaking out of the shower. If the seal is too large, it will be difficult to install and may cause the door to stick.

Step 1: Determine the Type of Seal

There are two main types of shower door seals: U-shaped seals and L-shaped seals. U-shaped seals are the most common type, and they are installed around the edges of the door. L-shaped seals are less common, and they are installed on the inside of the door.

Step 2: Measure the Length of the Door

Use a tape measure to measure the length of the door from one end to the other. Round the measurement up to the nearest inch. This will be the length of the seal you need to order.

Step 3: Measure the Height of the Door

Use a tape measure to measure the height of the door from the top to the bottom. Round the measurement up to the nearest inch. This will be the height of the seal you need to order.

Step 4: Measure the Thickness of the Glass

Use a caliper or a ruler to measure the thickness of the glass in the door. Round the measurement up to the nearest 1/16 of an inch. This will be the thickness of the seal you need to order.

Step 5: Order the Seal

Once you have all of the measurements, you can order the seal online or from a home improvement store. Be sure to order the correct type of seal for your door and the correct length, height, and thickness.

Conclusion

Measuring for a shower door seal is a simple task that can be completed in a few minutes. By following these steps, you can ensure that you order the correct seal for your door.